Ghozt v5 LED Sequencer
Professional Installation Recommended!
Please read the User Manual or visit the Ghozt Lighting Getting Started page before purchase!
- (5) 12v inputs, (28) output channels! (switched ground outputs)
- Show mode/Party mode!
- Sequential turn signals that self-calibrate to the car’s flasher unit
- One module controls up to two turn signals!
- Parking/running lights on/off animation
- Switchback parking light control (optional)
- Built-in parking light dimming for taillights (optional)
- Brake light control or High-beam dimmer capability
- Vehicle on/off animation
- Up to two looping show modes, triggered by a 12v switch
- 3 turns, 1 touch turn signal feature added to any car
- Reprogrammable after install! (Simply extend programming pins out of the housing)
- Extremely low power drain while in operation, sleep mode when idle
- Comes with default programming, or completely customizable using our software!
- Ultra-small form factor!
- Made in the USA
Minimal experience with retrofitting, soldering, and working with LEDs/resistors required. Headlight/taillight in most cases must be opened to gain direct access to LEDs, to install our sequencer. LEDs, headlights, or taillights are all sold separately.
Depending on the available stock, customers ordering “blank” units may receive heads/tails units, which can simply wipe their pre-programmed configurations.
Pickit3 Description
We now stock the Pickit3 programmer that you need to program your v5 LED Sequencers! No need to hunt one down via 3rd party any longer! This unit connects to your computer via USB port on one side, and to your V5 LED Sequencer with a 6 pin header connection! Using the MPLab software, also available for download here, you can re-program your LED Sequencers endlessly!
Reviews
There are no reviews yet