GT RGBW Chasing Cross Halos

NEW!: All GT RGBW Chasing Cross Halos now have an input & an output, meaning easier installation! Simply daisy chain the halos and/or strips together and you’ll only need one wire coming out of the headlight. These halos are 5V, not 12V like most automotive LED products, and MUST use the 5V transformer included. No secondary power wiring is needed for the RGB controller, it draws its power directly from the 5v transformer.

Why Capacitors? In our attempts to improve reliability, we have found that voltage spikes do not play nicely with 5V LEDs. So we created our inline GT Capacitors with a resistor on the data line to do everything we can to prevent voltage spikes in any form.

Dielectric Grease: Add this to all connections before you cover it in heat shrink to prevent corrosion. A good connection is a happy connection is a happy customer.

Extension Wires: Use these extension wires to give yourself a little extra playroom when installing your headlights, simply insert them between your controller/driver and the wires exiting the headlights. Make sure you are coating the connections with dielectric grease to prevent corrosion and taping them up.

Sizing: 80mm diameter with 90 extended bars.

Please Note

Addressable LEDs (the halos and strips themselves) have a small power drain even when off, regardless of the controller selected. If your car is driven daily, this should have no effect on you. If your car sits for a week+, consider installing a switch on the 12+ wire connecting to the battery (after the fuse).

Addressable LEDs are sensitive to temperature, especially, say, a 150+ degree bulb. If you’d like to get the longest life possible out of your purchase, consider running your halos/strips only has a DRL and have them turn off when your low beam is on.

Included

• All halos are sold in pairs.